If no fault code is entered now, with the water pumpand QLT connected -> Connect alternator.Ħ. Now connect the water pump and clear all fault memories, ignition off/on.ĥ. If no fault code is stored after all components (except QLT, as in 1.) are disconnected: -> The fault lies with one of the other BSD_components. If fault code no longer appears after QLT replacement: -> QLT was defective.Ĥ. If fault code is entered again after QLT replacement: -> Check wiring harness (BSD_BUS) and all plug-in connections for corrosion and shorts to ground/UBatt.ģ. If fault code is stored again: QLT is defective and must be replaced. Disconnect all BSD_components (alternator, battery sensor, water pump) except for the oil sensor. CAN Timeout BSD (Bit Serial Data Interface)ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |